From: MDKzone@aol.com 
Subject: [NMusers] NMPRD4 or LNP4 too small Error 
Date: Mon, August 16, 2004 1:12 pm

Does anyone know how to solve this problem?
 AN ERROR WAS FOUND ON LINE 245 AT THE APPROXIMATE POSITION NOTED:
    Y=F*(1+ERR(1)) + ERR(2)
                     X     
 THE CHARACTERS IN ERROR ARE: D00773
 288  SIZE OF NMPRD4 EXCEEDED; LNP4 IS TOO SMALL IN NM-TRAN AND NONMEM 


Your assistance is very much appreciated.
 
_______________________________________________________

From: "Sam Liao" sliao@pharmaxresearch.com
Subject: RE: [NMusers] NMPRD4 or LNP4 too small Error
Date:Mon, August 16, 2004 2:45 pm

Your model may have exceeded the limit in the no. of theta or eta.

You need to increase the size of certain parameters in nsize and tsize.
See Guide III, section III.2.9 (p25). 

Best regards,
Sam Liao
_______________________________________________________