Date: Tue, 17 Aug 1999 09:41:01 -0400 (EDT)
From: SRIRAM KRISHNASWAMI <Sriram.Krishnaswami@dupontpharma.com>
Subject: Error message

Dear NMusers

I would appreciate if someone could help me with the following error message.

forrt1: severe <33> : ENDFILE error, Unit 4, file MPIIIC2N01

The syntax on the control file looks like this

ESTIMATION METHOD=1 PRINT=5 POSTHOC
MAXEVAL MSFO=MPIIIC2N01 NOABORT

Thanks

Sriram

 

 

*****

 

 

From: "Gibiansky, Ekaterina" <gibianse@globomax.com>
Subject: RE: Error message
Date: Tue, 17 Aug 1999 11:07:36 -0400

This looks very much like the error that you get trying to use Digital 5 compiler without the patches. It can give you the error on some files and not on others. You can update your compiler by downloading the patch from the Digital Web page and following the instructions.

Ekaterina Gibiansky
GloboMax LLC
7250 Parkway Drive, Suite 430
Hanover, MD 21076
Voice (410) 782-2234
FAX (410) 712-0737
E-mail: gibianse@globomax.com

 

 

*****

 

 

Date: Tue, 17 Aug 1999 09:19:38 -0700 (PDT)
From: ABoeckmann <alison@c255.ucsf.edu>
Subject: Re: Error message

Like Ekaterina (see below), I assume that Siriam is using Digital Fortran, probably version 5.0.

It turns out that there are known bugs when the "fl32" command is used (DIGITAL's "PowerStation I/O compatibility mode"). These bugs do not exist when the "df" command is used (DIGITAL's "native DIGITAL Fortran I/O"). I don't know if the bugs were fixed in later versions.

Rather than patching the compiler, I suggest that with DIGITAL Visual Fortran, all compiles of NONMEM, PREDPP, and NM-TRAN be done using the "df" command rather than "fl32".

E.g., reinstall NONMEM with this command:

a:\setup a c nmv df y

Alison Boeckmann